Paul Jones says
This is a compact multi-process inverter for 230 V workshops, covering MIG/MAG, MMA and usually lift TIG from a single unit. In a bodyshop it suits general fabrication, light chassis work, jigs and brackets, as well as everyday repair welding on mild steel. It’s also handy in smaller garages where space and budget don’t justify separate sets.
In real use, the main considerations are mains supply and wire setup. On a typical 13 A or 16 A circuit you need to be realistic about duty cycle and plate thickness; it’s a good machine for thin to medium sections, not heavy structural welds all day. Spend time setting wire feed, voltage and inductance to keep heat input low on car body panels.
A common issue I see is poor results caused by tiny, budget extension leads or shared sockets – the machine then struggles at higher outputs. Keep it on a short, decent supply and it behaves much better.
Used within its limits, it’s a reliable, flexible workshop set that can cover most day-to-day welding efficiently.
Paul Jones, Technical Director
