ONSITE WELDED PANEL/SECTION MAG/MIG BRAZE/BOND/RIVET - AOM 030 | Quality Manufacture Approved Equipment Supplied and Serviced for vehicle body Repair Shops Skip to content

ONSITE WELDED PANEL/SECTION MAG/MIG BRAZE/BOND/RIVET - AOM 030

ATA AOM 030 welded panel section MAG BRAZE

THE BENEFITS

Your technicians can now do all the AOM 030 and AOM 009 panel testing on site in familiar surroundings, with the equipment they use every day.  The test will cover the technician for both ATA & PAS 125 (BS10125) requirements. It is also applicable for bonding test requirements.

Should the technician be required to do the AOM-006 Complex Met this is just a 2-hour practical test and avoids expensive days away from the site, hotels bills etc.

 

WHAT'S INVOLVED

The module requires the partial replacement of a welded sill section. Using a simulated sill the candidate will replace part of the section without damaging the inner strengthener.  Then using MAG /MIG BRAZE/ BOND and RIVET equipment to replace the section, to a tolerance of less than 2mm ready to accept filler.

The test has a time control of 4.5 hours for completion. 

Once completed satisfactorily a simple 10 

question online test is required to complete the module.

 

AOM-030 SILL SECTION TEST

AOM-030 SILL SECTION TEST

 

WHAT'S REQUIRED

A set area is required for the test with welding curtains to protect the rest of the workshop users. A serviced MAG Welder, MIG Braze and Inverter Spot Welder.

Each Engineer requires there own hand tools including air saw, belt sander,  hammer, chisels etc.

Drill bits, bonding material rivet tool and rivets are supplied. Spare Welding gases are also available.

CANDIDATE PROFILE

The senior technician should be working in the accident repair sector of the industry and have at least three years experience to ensure they are familiar with the skills, knowledge and techniques required to repair & replace body components, including returning vehicle alignment to manufacturer specification and rectifying body shell faults.

AOM- 009 What Is Involved? 

This is the same BS 4872 and BS1140 as you have always done with test welds produced on weld tags in the vertical up and upside down welding positions. The module just involves paperwork and accreditation to apply to your ATA personnel accreditation. accreditation to apply to your ATA personnel accreditation.